Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1
2
3
1. Spool retainer
2. Spool
3.
Pull the spool retainer up to remove it and remove the spool.
4.
To install the new spool, make sure the string is captured in one
of the retaining slots on the new spool. Make sure the end of the
string extends approximately 6 inches (152 mm).
5.
Install the new spool so that the string aligns with the eyelet in the
string head. Thread the string into the eyelet.
6.
Pull the string extending from the string head so the string releases
from the slot in the spool.
7.
Reinstall the spool retainer by depressing tabs into slots and
pushing down until spool retainer clicks into place.
Replacing the String
1.
Remove the battery.
2.
Remove the spool. See Replacing the Spool (Figure 15).
1
2
G015662
1. Spool
4
G015663
Figure 15
3. Slots
4. Tabs
Figure 16
2. Hole
Note: Remove any old string remaining on the spool.
3.
The spool will accept up to 15 feet (4.5 m) of string. Use only .065
inch (1.6 mm) diameter monofilament string.
Note: Do not use any other gauge or type of string, as this could
damage the trimmer.
4.
Insert the string into the anchor hole in the upper part of the spool
(Figure 16). Wind the string onto the spool in the direction shown
by the arrows on the spool.
5.
Place the string in the slot on the upper spool flange, leaving about
6 inches (152 mm) extended beyond the slot.
Note: Do not overfill. After winding the string, there should be at
least 1/4 inch (6 mm) between the wound string and the outside
edge of the spool.
6.
Replace the spool and the spool retainer. Refer to Spool
Replacement earlier in this manual.
Battery Pack Preparation For Recycling
WARNING
Upon removal, cover the battery pack's terminals with heavy-duty
adhesive tape. Do not attempt to destroy or disassemble the
battery pack or remove any of its components. Lithium-ion
batteries must be recycled or disposed of properly at the nearest
battery recycling facility.
Service
Should this item need service, take the product to your Authorized Toro
Service Dealer. Your Toro Dealer is specially trained to repair Toro
products and will ensure that your Toro stays "All" Toro.
Storage
•
Clean all foreign material from the product.
•
Store it in a well-ventilated place that is inaccessible to children.
•
Keep away from corrosive agents such as garden chemicals and
de-icing salts.
9
Publicidad
Tabla de contenido
