Installation Location Requirements; Preparing Cabinet Opening - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

14 INSTALLATION
Installation Location
Requirements

Preparing Cabinet Opening

This dishwasher is designed to fit a standard
dishwasher opening. An opening may be
needed on sides to route plumbing and electrical
connections.
• To ensure proper drainage, install the
dishwasher no more than 12 ft. (3.65 m) from
the sink.
• The location must have sufficient space for the
dishwasher door to open easily and provide at
least 0.1" (2 mm) between the dishwasher and
the cabinet sides.
• If installing the dishwasher in a corner, leave a
minimum of 2" (50 mm) between the dishwasher
and the adjacent wall.
• The adjacent wall must be free of obstructions.
• For flush installations only, you may remove the
cabinet brace inside the cabinet.
a
1
Select a location as close to the sink as
possible for easy connections to water supply
line, drain hose and electrical connection.
2
Check that all surfaces have no protrusions,
lips or other trim that would prohibit
dishwasher installation.
3
To allow for proper clearance of plumbing and
electrical, use the template included with the
literature to determine the clearance on the
side of the cabinet where the cabinet meets
the back wall. Using a 2 ½" diameter hole saw,
drill a hole in the target area as shown on the
template.
WARNING
• Installation damage is not covered by the
warranty, and leaks caused by improper
installation may result in property damage.
• Do not use existing holes unless they are in
the target area.
• Failure to properly locate the hole for the
water and drain lines may prevent the
dishwasher from installing flush with the
cabinets and could result in kinked, pinched,
crushed, stressed or damaged lines.
Checking the Cabinet Panel
This dishwasher is designed to work with a cabinet
front panel (not provided) which slides up as the
door is opened. Before installing the dishwasher,
check the weight and dimensions of the cabinet
front panel you have selected.
• The dishwasher can support panels weighing
5.5–24.2 lb (2.5–11 kg).