Quick Start - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

CAUTION
• To avoid product malfunction, do not pour
detergent in the dishwasher salt container.
• Wipe any salt residue from around the salt
container cover.
• Close the cover by aligning it horizontally and
turning it clockwise. If the cover is not tightly
closed, the salt solution can leak into the tub
and cause corrosion.
• After refilling the dishwasher salt, run a Rinse
cycle immediately without dishes to get rid
of any salt residue which could cause rust or
damage to the appliance.
NOTE
• Dishwasher salt can be purchased online or
from appliance retailers.

Quick Start

1
Load the Dishes
Scrape the dishes free of excess food, bones,
and any other hard, non-soluble residue.
Pull each rack out and load the dishes as
described in this manual.
2
Measure the Detergent
Using the guidelines in this manual, fill the
detergent cup with the recommended amount
of detergent and close the lid. If a prewash
is desired, the recess on top of the lid should
also be filled with detergent.
3
Close the Door
4
Turn on the Dishwasher
To turn on the display panel, press the Power
button.
5
Check the Rinse Aid
The Rinse Aid e icon will flash if the level
of rinse aid in the dishwasher is low. Add
rinse aid if the level is low to maintain the
effectiveness of the dry cycle.
6
Select the Cycle and Options
Select the cycle and options that best fit the
load by referring to the Cycle guide. The
display will show the estimated time for the
cycle and options selected.
7
Operate the Dishwasher
Method 1
• Press the Start button and then close the
door in less than four seconds to operate
the dishwasher. If the door is not closed
within four seconds, the white LED with time
flashes, an audible tone is heard, and the
cycle does not start.
Method 2
• Close the door first and then press the Start
button to operate the dishwasher.
If the door is opened during the cycle, the
dishwasher will stop. To resume the cycle, see
methods 1 and 2 above.
NOTE
• If the door is opened during the cycle and is
not closed within four seconds after selecting
the Start button, or if the door is closed
without pressing the Start button, the white
LED with time flashes, an audible tone is
heard, and the cycle does not start.
8
End of Cycle
When the cycle is complete, a chime will
sound and the display will show End until
the door is opened or Power is pressed.
To save energy, press and hold Delay
Start and Remote Start simultaneously
for three seconds to set the End display to
automatically turn off a few minutes after the
cycle ends.
CAUTION
• Do not open the door during operation
or immediately after the dishwasher has
completed the wash cycle as the built up
steam may cause scalding as the door is
opened.
NOTE
• Empty the lower rack first and then the upper
rack. This will avoid water dripping from the
upper rack onto dishes in the lower rack.
Auto-Off
The dishwasher automatically turns off after four
minutes of inactivity if paused or if no cycle is
started.
OPERATION 31