Preparing Water And Electrical Connections - Signature Kitchen Suite SKSDW2402P Manual Del Propietário

16 INSTALLATION
Preparing Water and
Electrical Connections
Connecting Water Supply Tube and
Power
*Water supply tube: 'Minimum 3/8" O.D. copper
tubing or metal braided dishwasher supply line
1
Connect the elbow
a
back of the dishwasher.
2
Connect the water supply tube to the elbow.
3
Tighten both connections using two adjustable
wrenches to avoid putting stress on the water
inlet valve.
4
Make sure the water supply is turned off.
Connect the water supply tube to the tap.
5
Insert the power plug into an outlet.
to the inlet valve on the
6
Turn on the water and check for leaks at the
connections.
• If there is a leak, reconnect the elbow.
• Do not cross thread or overtighten the
connections to avoid leakage.
7
Unplug the power cord.
8
Turn off the water supply and disconnect the
water supply tube at the tap.
WARNING
Water Connection
• Do not reuse an old hose. Use only a new
hose when installing the dishwasher. The old
hose could leak or burst causing flooding and
property damage. Contact a SIGNATURE
KITCHEN SUITE Customer Information
Center for assistance in buying a new hose.
Electrical Connection
• Use a time-delay fuse or circuit breaker.
• Operate this appliance with the correct
voltage as shown in this manual and on the
rating plate.
• The wiring must be grounded properly. If
in doubt, have it checked by a qualified
electrician.
• The appliance and outlet must be positioned
so that the plug is easily accessible.
• Do not use an extension cable or adapter
with this dishwasher.
• Do not overload the outlet with more than
one appliance.
• It is the personal responsibility and obligation
of the product owner to have a proper outlet
installed by a qualified electrician.