Signature Kitchen Suite SKSDW2402P Manual Del Propietário página 59

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
Cloudiness on
glassware.
Black or gray marks on
dishes.
Yellow or brown film
on inside surfaces of
dishwasher.
Spots and filming on
dishes.
Noise
Dishes don't dry.
LEDs do not illuminate. Power is not connected.
Spray arms do not
rotate smoothly.
Possible Cause
Combination of excessive
detergent and hard water.
Aluminum items rubbing
dishes during cycle.
Coffee or tea stains.
Low water temperature.
Overloading.
Improper loading.
Insufficient water
pressure.
Insufficient detergent.
Rinse aid dispenser is
empty.
Hard water buildup in the
tub.
Some level of noise is
normal during operation.
The dishwasher is not
level.
Nozzle arm knocking
against dishes.
Rinse agent dispenser
empty.
Dish was taken out of the
cabinet too soon.
Holes of spray arms are
blocked by food particles.
TROUBLESHOOTING
Solutions
• Use less detergent and use a rinse aid to
minimize the problem.
• Reposition the dishes.
• Eliminate the stain by using a stain removal
product.
• Water supply should be at least 120 °F for
best wash performance.
• Do not overload the dishwasher.
• See the Operation section.
• Water pressure should be between 20 and
80 psi.
• Add the recommended amount of detergent.
See the Operation section.
• Refill rinse aid dispenser.
• Remove all dishes, silverware and silverware
holder from dishwasher. Only racks should
remain in tub. For best results, use citric acid
powder (can be found in canning sections
of most grocery stores or online). Measure
3 tablespoons (40 g) of citric acid powder.
Fill main wash compartment with measured
powder. If you cannot find citric acid powder,
pour approximately one cup (200-300 mL)
of white vinegar into shallow bowl and place
in upper rack. Run Machine Clean cycle. Do
not use detergent.
• Detergent cover opening.
• Drain pump at the beginning of drain cycle.
• Adjust leveling feet.
• Reposition the dishes.
• Check and refill the rinse agent dispenser if
empty.
• Wait until the dishes have cooled before
unloading the dishwasher.
• Connect power supply.
• Clean the holes of spray arms.
59

Publicidad

Tabla de contenido
loading

Tabla de contenido