Operation - Carrera 18016013 Manual De Instrucciones

05. OPERATION

How to attach the pasta accessories
1. Loosen the locking screw and remove the cap (see fig.
2. Insert the desired attachment into the accessories coupler and tighten
the locking screw (see fig.
coupler, it may be necessary to turn the pasta attachment slightly.
How to use the pasta roller
1. Prepare the pasta dough (example recipe below).
2. Flatten the dough into an approx. 0.5 cm thick sheet. The width should
roughly correspond to that of the roller (no more than 14 cm).
3. Insert the pasta roller
4. Use the rotary switch
ing out the switch, turning it to position 8 and allowing it to lock in place.
5. Switch on the food processor and set the speed control to speed level 1;
the rollers start to rotate.
6. With the rollers set to position 8, pass the dough through them several
times until it is flat and smooth. After each pass, dust the dough with a
little flour and fold it lengthwise.
7. Pass the dough through the rollers several times, gradually reducing the
setting (8–1) until the desired thickness has been achieved.
NOTE: The more often the dough is passed through the rollers, the flatter and
smoother it becomes and the better your pasta will turn out. TIP: To keep the
sheets from drying out, cover them with a damp kitchen towel.
20 EN
). In order for the shaft to engage with the
B
1
1
into the food processor as described above.
2 to set the largest possible roller distance by pull-
).
A