Start-Up - VITO PRO-POWER WR2 130B LITE Manual De Instrucciones

▪ Never operate the device by doing repeated and
quick movements of pressing /releasing the gun
trigger. This may result in components failure and
under pression couplings failure;
▪ Do not operate pressure washer without water, as it
will damage the water pump seals. Always turn the
water on before starting the appliance;
▪ To prevent accidental discharge of high-pressure
water, the gun trigger safety lock should be engaged
whenever the pressure washer is not being used;
▪ When the high-pressure washer is under pressure
and the trigger is engaged, a gun recoil
force/kickback can occur due to the force of the
water jet. Adopt a stable and firm posture. Hold the
gun firmly with both hands in order to prevent
accidents;
▪ Do not use the equipment with other people nearby
unless they are wearing personal protective
equipment;
▪ Never point the water jet towards people, animals,
other appliances, electrical components or the high-
pressure washer itself;
▪ Do not put you hand, fingers or body in front of the
adjustable nozzle. The jet may hurt you.
▪ Keep the high-pressure hoses connected to the
washer and spray gun while the system is under
pressure. Make sure the appliance is turned off and
without any pressure before disconnecting the
hoses;
▪ Do not make any modifications to the appliance,
couplings, hoses or other connections;
▪ Do not use the pressure washer to pump fuel or other
flammable liquids;
▪ Always wear safety goggles and individual protective
equipment such as dust mask, hearing protection,
closed-toe shoes, ear plugs;
▪ This device is prepared to work with clean water and
operating temperature between +5°C and +50°C. The
operating pressure of the inlet water must be less
than 7 bar;
▪ Use high-pressure hoses, couplings and fittings
according to technical data and manufacturer's
recommendations. These accessories are important
to ensure safety issues;
▪ Do not operate the high-pressure washer at
excessive pressure (hoses, connectors, fittings);
▪ Vehicle tyres or tyre valves are susceptible to be
damaged from the high-pressure jet and may burst;
▪ It is not allowed to clean surfaces containing
asbestos;
▪ Cleaning areas should have the necessary slope and
drainage to reduce the possibility of falling;
▪ Prior to starting the pressure washer in cold weather,
be sure ice has not formed in any part of the
equipment;

Start-up

The device is equipped with an automatic
START/STOP system, based on water pressure. The
motor on this high-pressure washer does not run
continuously. The motor only runs when the gun trigger
is pressed. Each time it is released, the washer stops
automatically.
1. Check if the appliance is in an upright position;
2. Open the water supply tap;
3. Set the trigger gun safety lock (16) to the right to
allow the trigger to be activated;
4. Press the gun trigger (15) until all the air has escaped
from the pump and water hose;
5. Plug in the power cord (10);
6. Set the "ON/OFF" switch (3) to "ON" position;
7. Press the gun trigger to start spraying;
8. If you need to change the spray pattern, turn the
nozzle to the left/right (18);
9. Adjust the distance between the nozzle and the
cleaning surface;
31