Esoteric Grandioso G1X Manual Del Usuario página 9

A
10MHz OUT connectors
These output 10MHz clock signals (sine wave, 0 . 5 Vrms output
level, 50Ω output impedance) .
Connect these 10MHz OUT connectors to the clock input con-
nectors of CD players, D/A converters and other digital devices
that support 0 . 5 Vrms 10MHz input .
Use commercially-available BNC coaxial cables (with 75Ω
or 50Ω impedance) for connection.
Set the toggle switches according to how the connectors are
being used .
A.GND (Adaptive Zero Ground)
This outputs a 10MHz clock signal .
o The amp is used to drive the negative connector so that it
becomes 0 V .
OFF
Disabled
NOR (NORMAL)
This outputs a 10MHz clock signal .
B
LED brightness adjustment knob
Use this to adjust the brightness of the indicators .
C
PREHEAT switch
ON
This turns the power for the crystal oscillator on regardless of
the POWER button setting . This shortens the amount of time
until the oscillator stabilizes after the unit is turned on .
o Due to the nature of the crystal oscillator, continuous
operation stabilizes the precision of operation, so we rec-
ommend turning this ON .
o When the unit power is off, clock is not output even
though the crystal oscillator is operating .
o Power will be consumed even when the unit power is off .
OFF
The POWER button turns the crystal oscillator on/off with the
unit .
o Set this switch when the unit power is on .
D
SIGNAL GND grounding terminal
Connecting this to the grounding terminal of a connected digital
device, amplifier or other equipment might improve the audio
quality .
o This is not a safety grounding terminal .
E
Power inlet (~IN)
Connect the included AC power cord to this AC inlet . After com-
pleting all other connections, plug the power plug into a power
outlet .
V
Use only a genuine ESOTERIC power cord. Use of
other power cords could result in fire or electric
shock.
V
Disconnect the power plug from the outlet if you
will not use the unit for a long time.
9