MSA Latchways PRD Instrucciones De Uso página 8

Descender device/line
The following checks shall be carried out each time the Latchways PRD descender device is used:
Figure 4
EN
Figure 5
Figure 6
Figure 7
8
• Inspect the attachment point connector for signs of damage,
excessive wear, distortion, corrosion or cracking.
• Ensure that the descent line is not paid out of the device, this would
indicate that a descent has occurred (Figure 4). If descent line is paid
out the Latchways PRD descender device shall be removed from
service and advise sought from MSA or authorised agent.
• Note: Attachment point size and shape may differ from that shown
in the diagram.
• Open the backpack containing the device (Figure 5).
• Inspect the general condition of the device for signs of damage or
corrosion. If damaged the Latchways PRD descender device shall
be removed from service and advise sought from MSA or authorised
agent.
• Inspect descent line for any 'slack' between the drum and rack
(Figure 6). If the line is slack the Latchways PRD descender
device shall be removed from service and advise sought from
MSA or authorised agent.
• Check the legibility of the product markings.
• Inspect the release pin for signs of damage, distortion, corrosion
or cracking. Ensure that it is engaged. Ensure that the red release
cord is positioned under the release pin and that the load-line
webbing is looped around the release pin (Figure 7).
• Ensure that the green release pin clip is present and undamaged—
check for signs of damage, distortion or cracking (Figure 7).