Pre-Use Checks - MSA Latchways PRD Instrucciones De Uso

Anchor point requirements
ANSI The anchor point shall be able to sustain a minimum certified load of 3600 lbs
(16 kN) or 5000 lbs (22.2 kN) in the absence of certification. Refer to ANSI Z359.14-
2012 CLASS B.
CSA The anchor point shall be able to sustain a minimum load of 5000 lbs (22.2 kN).
Refer to CSA Z259.15 CSA Z259.13, CSA Z259.15
Note: If multiple fall arrest systems are attached to the same anchor point the strength
requirement shall be multiplied by the number of personal fall arrest systems.
Lanyard
Always use an energy absorbing lanyard or retractable type fall arrestor that complies with the
relevant standards within the country of use. In some Approved harness variants, side attachment
points are included. These attachments are only to be used for a suitable work positioning lanyard.
ANSI
CSA
Connectors
Connectors shall conform to the relevant national standards and must be compatible.
ANSI
CSA

Pre-use checks

The Latchways PRD has been designed to be easy to use, incorporating a range of features
to aid pre-use checks and on-site periodic examination. This minimises the need to return the
device to MSA or an authorised agent. No repairs, modifications or alterations are to be carried
out on the Latchways PRD. If any part of the Latchways PRD is found to be faulty, or a fault
is suspected, the device shall be removed from service and advise sought from MSA or an
authorised agent.
Problem identified
ANSI Z359.1 or ANSI Z359.13
CSA Z259.2.2, CSA Z259.11
ANSI Z359.1 or Z359.12
CSA Z259.12
Passes checks
EN
7