Publicidad
Step 6
Carefully turn your unit over onto its front edges. Unfold
å
the BACK (G) and lay it over your unit.
Make equal margins along the top and both side edges
å
of the BACK (G). Push on opposite corners of your unit if
needed to make it "square".
Fasten the BACK (G) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up
å
over the UPRIGHTS (C and D).
Page 10
G
C
Do not tap NAILS along the
bottom edge of the BACK.
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(38 used in this step)
These holes must line up with the UPRIGHTS (C and D).
D
408750
Caution
1N
NAIL
For support, place packing
foam and magazines here.
www.sauder.com/services
Publicidad
