Asus P Serie Manual De Instalación página 4

Installing an Intel
1. Locate the CPU socket on the
motherboard.
2. Press the load lever with your thumb
(A), then move it to the left (B) until it
is released from the retention tab.
CAUTION! To prevent damage to the
socket pins, do not remove the PnP cap
unless you are installing a CPU.
3. Lift the load lever in the direction of the arrow to a 135º angle.
4. Lift the load plate with your thumb and forefinger to a 100º angle (4A), then
push the PnP cap from the load plate window to remove (4B).
5. Position the CPU over the socket, making sure that the gold triangle is on the
bottom-left corner of the socket. Fit the socket alignment key into the CPU
notch.
6. Close the load plate (6A), then push the load lever (6B) until it snaps into the
retention tab.
4B
3
Installing an Intel
1. Place the heatsink on top of the installed CPU, making sure that the four
fasteners match the holes on the motherboard.
2. Push down two fasteners at a time in a
diagonal sequence to secure the heatsink and
fan assembly in place.
3. When the fan and heatsink assembly is in
place, connect the CPU fan cable to the
connector on the motherboard.
CAUTION. Do not forget to connect the CPU
fan connector! Hardware monitoring error can
occur if you fail to plug this connector.
4
CPU
®
PnP cap
Load plate
4A
Alignment key
CPU heatsink and fan
®
Installation manual
Retention tab
A
B
Load lever
Gold
triangle
mark
A
B
1
6A
6B
B
A
1