Starting Up; Features; The Speedster; Operating Components - FANATEC SPEEDSTER 3 Manual De Instrucciones

2.2 Starting Up

1) Turn off your console.
2) Connect the SPEEDSTER
Controller port 1 of your console.
3) Insert a driving game disc.
4) Turn on your console again.
N O T E :
!
The steering wheel should be in the middle position when the
console is turned on and must not be moved as calibration
takes place in the start-up phase.

3.0 Features

– Can be played on a table (optional)
– Good grip thanks to high-quality rubber coating on steering wheel
– "Formula 1" style manual shift
– Analog-mode acceleration/braking with pedals or gear levers
– High quality thanks to "Germaneering™"
– Ergonomic, non-slip pedals
– Can be played in digital mode
– Tuning feature with the following functions:
Configurable dead zone
•
Configurable sensitivity
•
Programmable horn button and gear levers
•
Adjustable vibration effects
•
Tracking control to prevent skidding
•
– 11 buttons (3 of which can be programmed) plus directional buttons
® 3 to

3.1 The SPEEDSTER

Operating Components

HORN (L2)
L2
L1
START SELECT

3.1.1 The Steering Wheel

The steering wheel controls all steering movement.
The buttons are located in the center of the wheel:
, , L1 and L2 on the left,
MODE, START, SELECT and TUNING in the middle.
The horn button with the FANATEC-logo is assigned to "L2 button"
When the pedals are connected, the left gear lever is assigned to
the "L3 button" and the right gear lever: "R3 button". If you want
to drive using the manual shift, you must configure and store this
assignment in the game (recommended).
If a setting is not possible in the game, you can change the
assignment of the shift levers. For more information, see "Tuning".
Without pedals, the left gear lever transmits:
gear lever: X
3
® 3
R2
R1
MODE TUNING
, X, R1 and R2 on the right, and
and the right