Connecting The Temperature Sensor; Setting The Unit Of Temperature; Initial Use; Position During Operation - FLORABEST FFGT 433 A1 Manual Del Usuario E Instrucciones De Seguridad

FLORABEST FFGT 433 A1

Close the battery compartment (19) by putting the cover
(20) back in place. Make sure that it snaps audibly into
place.
Receiver:

Turn off the receiver via the ON/OFF switch (12).

Remove the fastening clip (9) from the back by sliding it to
the left.

Now remove the battery cover (8) by pressing it gently
and sliding it in the direction of the arrow.

Insert two AAA 1.5 V batteries (Micro LR3), ensuring that
the polarity is correct. Follow the marking in the battery
compartment (10).

Close the battery compartment (10) by putting the cover
(8) back in place and sliding it away from the direction of
the arrow.

Now attach the fastening clip (9) by positioning it on the
open side of the guide and sliding it as far to the right as it
will go.

7.2 Connecting the temperature sensor

Plug the plug (15) into the jack (16) on the side of the
transmitter (13). When not in use, the temperature sensor (14)
can be stored in the holder next to the jack (16).

7.3 Setting the unit of temperature

You can choose between two temperature units (°C and °F).
To do so, slide the selector switch (11) in the battery case (10)
to the desired position.

8. Initial Use


Set the transmitter's (13) ON/OFF switch (18) to the ON
position. The red LED (17) blinks every four seconds
during operation.

Now turn on the receiver (1) by setting the ON/OFF
switch (12) to the ON position. A beep sounds and the
LCD (2) lights up briefly with blue backlighting before
switching to red.
If the temperature sensor (14) is not connected to
the sensor (13) or the wireless connection between
the transmitter (13) and receiver (1) is interrupted,
the LCD (2) will display '- - -' as the current
temperature.
If this happens, ensure that the plug (15) is plugged
into the jack (16) correctly and that the distance
between transmitter (13) and receiver (1) is not too
great. If necessary, turn off the transmitter (13) and
receiver (1) for around three seconds and turn them
on again. That should fix the problem.

8.1 Position during operation

The transmitter (13) has a range of approximately
49.2 feet/15 meters. Please make sure that the
transmitter (13) and receiver (1) are not too far
apart. Otherwise, it will not be possible to measure
the temperature correctly.
8 - US-EN