PowerSmith PAVC101 Manual Del Operador página 11

IMPORTANT!
properly installed fi lter; doing so will result in dust blowing out the vents & exhaust
port.
Following canister & fi lter cleaning, and then fi lter inspection and fi lter replacement, if necessary,
reassemble the Ash Vacuum before storage.
WARNING:
trouble shooting.
SYMPTON
Vacuum does not operate
Dust escaping
Metal nozzle, hose or
canister become HOT
Reduced or no suction
Nozzle clogs easily
*Do not wear gloves to vacuum ash that is warmer than normal or hot.
Only use original or manufacturer approved accessories and spare parts.
NOTE:
PowerSmith™ Ash Vacuum can only use PowerSmith™ specially designed
Ash Vacuum Filter
Do not use the vacuum with a damaged fi lter or without a
TROUBLESHOOTING
Always disconnect the plug from the power outlet before
POSSIBLE CAUSES
No power to motor
1. Filter not installed
2. Holes or torn fi lter
3. Filter gasket not laying fl ush on
canister top edge
4. Motor housing not seated or
secured
Ash is too warm or hot
1. Clogged nozzle, hose or vacuum
port
2. Canister full
3. Filter clogged with fi ne dust
Vacuuming too much ash at once
ACCESSORIES
PAAC301.
English
- Plug into power outlet
- Check power supply for blown
- Call customer service help line.
1. Install the fi lter
2. Replace the fi lter
3. Check and reinstall the fi lter.
4. Reinstall motor housing.
Or, lock down both clamps.
Allow ash to cool before
vacuuming *
1. Check for blockage & remove
2. Empty canister
3. Clean fi lter or replace with a
new fi lter.
Red & use manual's "Usage Hint"
section.
11
REMEDY
breakers/fuses – replace if
needed.