Important - PowerSmith PAVC101 Manual Del Operador

Although the Ash Vacuum has special features for vacuuming warm & cool ashes from fi replaces, stoves,
and BBQ's, it may also be used for dry vacuuming as a shop/garage vacuum, a household vacuum, or as a
blower. In the Operation section are special instructions for various ash vacuum uses.
WARNING:
warnings. Safety is a combination of common sense, staying alert, and knowing how
your Ash Vacuum works.
WARNING:
in areas with fl ammable gases, vapors or explosive dust in the air. Flammable
gases or vapors include but not limited to: lighter fl uid, solvent type cleaners, oil-
base paints, gasoline, alcohol or aerosol sprays. Explosive dusts include but are
not limited to: coal, magnesium, aluminum, grain or gunpowder. Do not vacuum
explosive dust, fl ammable or combustible liquids or hot ashes. To reduce the risk of
health hazards from vapors or dusts, do not vacuum toxic materials.
ON/OFF SWITCH
After plugging the power cord into an outlet, the unit is turned on by pushing the switch from position "O"
to position "I". The symbols used on the toggle switch are international "On & Off" symbols. "O" is the
symbol for "OFF" and "I" is the symbol for "ON".
NOTE:
Static shocks are common in dry areas or when the relative humidity of the air is low.
Vacuuming fi ne debris with your Ash Vacuum can cause static charge on the hose or on the vacuum. The
best remedy to reduce the frequency of static shocks in your home when using this vacuum is to add
moisture to the air with a humidifi er.
ASH VACUUM USE
1. Before connecting the power cord to power source, check that the vacuum is properly assembled with
the metal nozzle installed.
CAUTION
: NEVER use the ash vacuum without the metal nozzle in place.
2. Ensure the On/Off switch is in the "O" (OFF) position.
3. Place the Ash Vacuum near the fi replace or stove you are cleaning and make sure the ash inside is
cool.
4. Insert the power cord plug into an outlet near your work area and push the switch to the "|" (ON)
position.
5. Using the metal nozzle only, begin vacuuming the ash.
6. As you vacuum, constantly check the nozzle, hose, canister, fi lter and motor for excessive
temperatures. If you notice an increase in temperature, turn off the vacuum immediately. Unplug the
vacuum and remove the vacuumed material from the canister and fi lter bag. Allow the vacuum and
the material to be vacuum to cool before continuing to vacuum.

IMPORTANT!

canister fi lls with ash. Check it regularly to see if the vacuum canister is full.
7. Continue to run the vacuum for about 30 seconds after cleaning is complete to be sure any material
remaining in the hose is safely deposited into the canister. Move the vacuum switch to the OFF
position, then unplug from the outlet.
OPERATION
Be sure to read, understand and apply all safety instructions and
To reduce the risk of fi re or explosion, do not operate this vacuum
O = OFF
The FULL indicator area will gradually become RED as the
English
I = ON
8