Klarstein Smartwave Manual Del Usuario página 23

EN
A
L
32mm
Remove the expansion rubber and screws from the accessory bag, drill four holes with
a diameter of 8mm on the wall, the hole depth is 70mm, the hole distance is 32mm,
300mm≤L≤450mm install the expansion rubber in the fitting in the hole, and then
mount the wall bracket from the accessories. Remove it and fix it to the wall with a 5*60
screw.
B
Place the wall bracket on the corresponding screw on the back of the heater, and then
adjust the wall bracket to the proper position with the nut from the accessory bag and
then lock it to ensure it will not loosen..
23