Installing The Ceiling-Lens; Installing The Wall-Lens - Eminent EM6581 Manual De Usuario

12 |
ENGLISH

2.5 Installing the ceiling-lens

Figure 2a, lens for wall mounting Figure 2b, lens for ceiling mounting
Figure 2c, Ceiling lens with shading cap
When you mount the motion sensor at the ceiling, you need to install the lens from
figure 2b. Remove the old lens from the motion sensor by turning the ring of the lens
against the clock. By turning the motion sensor upside-down, you can easily remove
the lens. Check if the shading cap is mounted on the ceiling-lens and remove this
(figure 2c). Install the ceiling-lens in the motion sensor and turn the ring of the lens to
the right.
The range of the ceiling lens is about 4 meter.
When desired, you can install the included shading cap. This shading cap is divided in
segments of 30 degrees. You can blank off parts of the detection zone by leaving
those segments on the shading cap. The motion sensor will detect only movements in
the segments that were removed.
When the shading cap is mounted will all 12 segments still intact, no motion can be
detected.

2.6 Installing the wall-lens

When you mount the motion sensor on the wall, you need to use the lens from figure
2a. Remove the old lens from the motion sensor by turning the ring of the lens against