GET RPM DASH Guia página 6

LAUNCH CONTROL MODE TARGET SETTING
RPM display Launch Control
2 sec
Press the button for 6 seconds in "RPM display" mode.
The central red LED "LC" will flash, indicating that the system has switched to the
setting phase for the desired engine RPM threshold to reach when starting.
Release the button.
The blue LEDs indicate the selected engine RPM. Pressing the button makes it possible
to turn the LEDs on in sequence to the desired value.
The fixed LED indicates the effective value shown on the display (e.g. 10 = 10,000 RPM).
The flashing LED indicates 500 RPM more than the value indicated on the display (e.g.
10 = 10,500 RPM). The LEDs will turn on progressively each time the button is pressed.
If the required value is exceeded, it can still be reached by continuing to press the
button (once the maximum value is reached, the selection restarts from 5000 RPM).
Once the desired level is reached, release the button.
After 2 seconds, the LC LED will start to flash quickly, indicating that the set
threshold was saved. The device will automatically switch to the RPM display mode.
EN
Launch Control target
+4 sec
10
SHIFT LIGHT SETTING
RPM display Launch Control
2 sec
Press the button for 8 seconds in "RPM display" mode.
The red LED located at the bottom of the RPM Dash will flash, indicating that it has
switched to the shift light setting phase.
Release the button.
The blue LEDs indicate the selectable engine RPM. Pressing the button makes it
possible to turn the LEDs on in sequence to the desired value.
The fixed LED indicates the effective value shown on the display (e.g. 10 = 10,000 RPM).
The flashing LED indicates 500 RPM more than the value indicated on the display
(e.g. 10 = 10,500 RPM).
The LEDs will turn on progressively each time the button is pressed. If the required
value is exceeded, it can still be reached by continuing to press the button (once the
maximum value is reached, the selection restarts from 5000 RPM).
Once the desired level is reached, release the button.
After 2 seconds, the LC LED will start to flash quickly, indicating that the set threshold
was saved. The device will automatically switch to the RPM display mode.
Launch Control target Shift Light setting
+4 sec +4 sec
11
EN