Fulgor Milano CH 302 ID TC Manual De Instrucciones página 21

Display
The symbol C means that this
C
cooking point can be configured
A flashing "C" means that this
cooking point is currently configured.
"-" appears on the display after
C/-
If the symbol "-" does not appear,
you must check for the possible
A flashing "E" on all the cooking
point displays means that, at this
E
time, all configurations have been
E/2
(the error code may be The induction modules are too hot
different for some TCs)
Pan not suitable, such as loss of
E/3 magnetic properties due to the
temperature of the bottom of the pan
Induction modules are not
configured (all the induction modules
E/4 can be accessed through the bus,
but no element is assigned to this
No communication between the UI
E/5
and the induction module
E/6
E/7
E/8
E/9 Defective induction sensor
E/A
Description
configuration.
causes of E/5.
erased.
1. pan/glass temperature too high
2. NTC -> electronic temperature
The pan generates working points
that are not allowed by the induction
module and that could damage parts
Induction module is not configured
cooking point)
The induction module has no power
supply voltage. Incorrect connection
(cable) or induction module defective
1. Frequency detection, mains
Mains fault
This can occur with incompatible
Unknown error versions of the induction module or
Fan error Fan or electronic control defective
The sensor value is invalid, defective
The intrinsic control has detected a
Hardware error
defective command component
21
Probable Cause
No error, the User is in the
configuration menu
No error, the User is in the
configuration menu
No error, the User is in the
configuration menu
too high.
(such as the IGBT)
defective.
2. Over-voltage
Touch Control
sensor or electronics
Solution
Place the pan on the induction
module
Wait for "-" or stop the configuration
with the corresponding selection
key; the C symbol stops flashing.
Manual re-configuration
The induction module must cool
1. This error occurs after 8 seconds
and the cooking point can be used
again. If the error occurs repeatedly,
the pan must be removed.
2. If the error occurs even without
a pan, or it is a pan that normally
works, the induction module must be
replaced because it is a hardware
error.
1. Erase the global configuration and
re-configure.
2. Assign the induction modules
through the configuration menu.
3. If you cannot configure the
module, it must be replaced.
Check connections with cables
and the power supply module; if
everything is correct, replace the
induction module
Check connections with cables
and the power supply module; if
everything is correct, replace the
induction module
Replace the induction module or
Touch Control
Replace the induction module
Replace the induction module
Replace the induction module
GB