Tendido De Los Cables De Control En El Interior Del Armario (Bastidores R6 A R8) - ABB ACS880-07 Serie Manual De Hardware

5. Arrange the bunches according to size from thickest to the thinnest between the E
5. Disponga los haces por tamaños, desde el más grueso al más fino, entre las almohadillas
conductive cushions.
conductoras EMI.
6. Si más de un cable debe pasar a través de un pasacables, séllelo aplicando Loctite
5221 (o un sellador adhesivo equivalente) en su interior.
6. If more than one cable go through a grommet, seal the grommet by applying Loct
5221 (catalogue number 25551) inside the grommet.

Tendido de los cables de control en el interior del armario (bastidores R6 a R8)

Routing the control cables inside the cabinet
Use the existing trunking in the cabinet wherever possible. Use sleeving if cables are
against sharp edges. When running cables to or from the swing-out frame, leave enou
slack at the hinge to allow the frame to open fully.
Connecting to the inverter control unit (A41)
Connect the conductors to the appropriate terminals (see page 127) of the control uni
terminal block X504 (option +L504).
Connect the inner twisted pair shields and all separate grounding wires to the groundi
clamps below the control unit.
The drawing below represents a drive with additional I/O terminal block (option +L504
Without the block, the grounding is made the same way.
Notes:
•
Do not ground the outer shield of the cable here since it is grounded at the lead-
through.
•
Keep any signal wire pairs twisted as close to the terminals as possible. Twisting
wire with its return wire reduces disturbances caused by inductive coupling.
+H351, +C129
Electrical installation
Instalación eléctrica 123
+C129+F289
11