Aircare PILLAR PU320DDWD Manual Del Usuario página 6

9
7
5
8
6
6
Attach the AC adapter to the PILLAR
and plug in your unit and remove the
plastic tab from the remote.
7
Press the power button
the unit or the remote. Your PILLAR
has three mist output levels and it will be on the
highest output when you turn it on. Pushing the
power button again will set the output to medium,
and pressing it again will set the output to low.
8
Press the humidity setting button
on either the unit or the remote to set
your humidity level from 25% to 65%. Your mist
output will pause when the set humidity level is
reached, and resume when the humidity dips
below your setting. When set to 65%, your unit
will run continuously.
9
Press the timer button
unit or the remote to run your PILLAR
for a set period of 1, 2, 4, or 8 hours. The timer
icons will show on the display when the timer
is on. Turn the timer off by pressing the timer
button again.
About the display:
• While running, your PILLAR will alternately display the temperature
and relative humidity on the screen.
• When the water tank is empty, the unit will beep and display a red
water droplet on the screen. Your PILLAR will turn off until it is refilled.
That's it! Your PILLAR is ready to use.
on either
on either the