Full-Arm-05 Accessories - Favero FULL-ARM-05 Manual Del Usuario

for doubling a Data-Line output, is also available.
To prevent the annoying continuous noise that
occurs in the sabre and the foil when the fencers
are not connected, the programme inhibits the
sound after a set period of time from when both
f u l l - a r m - 0 5 A c c e s s o r i E S
For the various accessory articles available for
running the Full-Arm-05, such as transformers,
batteries and battery chargers, see Chapter 1-
POWER SUPPLY.
Art.852 BOX-04 Carrying case.
In addition to the Full-Arm-05 , this case can also
house other accessories, such as the battery
(Art.828), the battery charger (Art.829) and the 1m
high table-top stand (Art.873).
Art.873 1m high table-top stand.
Useful for positioning the Full-Arm-05 above the
level of the fencers. When disassembled into two
pieces, this stand can be inserted into the carrying
case Art.852 BOX-04.
anchoring the stand to the table as well as 1.2m
extension cord, if the power cord must be
lengthened.
Art.880 DATA-LINE Doubler
connect more than 2 repeaters, this inexpensive
accessory connector can double a single Data-Line
output.
PANEL-02
Art.835
The PANEL-02 is useful for long-distance display
of all the information present on the FULL-ARM-
05, but in a larger-size.
Required voltage: 12Vdc (minimum 10Vdc,
maximum 16Vdc), or 12 Vac (minimum 10Vac,
maximum 13Vac).
The power is supplied without the need to observe
the polarity.
Current consumption: 0.9A with the lights off,
maximum 4.5A. Consumption of the white lights is
reduced to one-third just 30 seconds after they are
switched on, while still ensuring their 180 visibility.
The PANEL-02 comes complete with a power cord
with clamps (Art.856) for hooking up to a car
battery and with a connector for the possible self-
help construction of a custom-designed cord.
If the PANEL-02 is run on the main supply, the
following articles are available:
-- For the 230 V power supply:
Art.854-A Transformer 230/12V 3,4A
-- For the 115V power supply
Art.854-B Transformer 115/12V 3,4A
The PANEL-02 comes complete with two extension
A clamp is provided for
.
If it is necessary to
Repeater panel
°
:
weapons have been disconnected. Also the white
lights are switched off to limit consumption. As
soon as a weapon is connected, the signals
appear again.
cables, one 2.5m and the other 15m in length, for
connection to the Full-Arm-05 by using the
corresponding Data-Line sockets.
extension cables up to 100m in length are also
available.
The possibility of connecting more panels to the
same apparatus offers the advantage of easily
locating the display boards close to the public, or of
creating double-sided panels by placing them
back-to-back. In this latter case, a special
commuter switch located on the back (DISPLAY:
INVERTED-NORMAL) makes it possible to invert
the displays so that they are identical from the
same side, including the red and green lights
Also supplied with the PANEL-02 are two special
stands, one high and one low, which can be placed
on a table. When using the high support, make
sure that it is firmly fastened to the table by the two
clamps provided with PANEL-02.
For transport, use of the special carrying case,
Art.850 BOX-01 is recommended.
not included with PANEL-02.
LIGHTS REPEATER
Art.894
Power supply: there are 3 versions.
- Art. 894-A: for 230 V power supply, 6VA max.
- Art. 894-B: for 115 V power supply, 6VA max.
- Art. 894-C: for 12 V power supply, 400mA max.
The Lights Repeater enables long-distance
repetition of the two white lights and the red and
green light. All the lights are formed by units of
high-efficiency LED's, thereby providing low
energy consumption and almost unlimited life. To
make the product especially economical, its
standard version uses yellow LED's to signal the
white lights.
The Lights Repeater is designed to be easily fitted
to the wall and it is ideal for using on fixed systems
when attached to the ends of the piste visible to the
fencers.
INSTALLATION of the Lights-Repeater 230V
(Art.894-A) and Lights-Repeater 115V (Art.894-
B): These two versions are supplied with a
power cord and plug. Insert the telephone plug
into the DATA-LINE socket.
Repeater to the wall by using the two front
holes and the two screws supplied.
10
ENGLISH
If necessary,
.
This item is
Fix the Lights