R E M O T E C O N T R O Loperations - Favero FULL-ARM-05 Manual Del Usuario

display period, the volume is changed. There are
three levels: v1 (low), v2
MINUTES CHRONOM.
amount of time set for the match, in minutes. If the
key is pressed again during the display period, you
can change that figure from 1 to 9. The set figure
is the one that is loaded into the chronometer by
using the SET key on the remote control.
F1 Key : Non-activated function key.
2éme FONCTION key
function written in red below the keys so prepared.
In the ensuing text, these will be described as
"secondary" functions.
2éme FONCTION + TEST
possible to control the correct functioning of all the
lights. Furthermore, a short-circuiting between all of
the 7 weapon sockets (3+3+piste) will produce a
continuous sound indicating that the circuits
controlling the weapons are functioning correctly.
If the TEST key is pressed again, the lights on the
apparatus will change pattern, which is an effective
way to attract the attention of the potential buyers of
the Full-Arm-05.
To stop the test phase, press the ON-OFF key.
2éme FONCTION + AQUIS.TÉLÉC.
keys make it possible to acquire a new remote
control. Once these two keys are pressed in
succession, it is necessary to press the
TELEC.AQUIS. key on the remote control within no
more than 5 seconds.
2éme FONCTION + ÉCHANGE
provide the exchange of two point scores and are
useful when the fencers change position.
2éme FONCTION + F2
utilised at the moment.
3- REMOTE CONTROL KEYBOARD
The functions carried out by the 18 keyboard keys
are described below.
TELEC.AQUIS. key: It enables the Full-Arm-05 to
acquire the code number of the remote control in
order to recognise it later.
supplied with the Full-Arm-05 is already enabled,
so acquisition becomes necessary only when the
remote control is changed. In order for the new
remote control to be recognised, the
FONCTION + AQUIS.TÉLÉC.
p r e s s e d i n s u c c e s s i o n o n t h e F u l l - A r m - 0 5
keyboard and then, within no more than 5 seconds,
the TELEC.AQUIS.
must be pressed (see Chapter 2- Full-Arm-05
KEYBOARD).
SET key : It loads the length of the match on the
chronometer in minutes (programmed with the
MINUTES CHRONOM.
keyboard). In order for this to occur, the
chronometer must not be in the process of
counting.
START-STOP key :
chronometer.
(medium) and v3 (high).
key : It displays the
: It activates the auxiliary
keys : These keys make it
keys: These
keys: These keys
keys: A function not
The remote control
2éme
keys must be
key on the remote control
key of the Full-Arm-05
It starts and stops the
MISE A ZERO, [+]
respectively zero out, increase and decrease the
score.
RÉARM. key : It causes rearmament.
MATCH COUNT key
matches. Since there is a 3-match limit, 1, 2 or 3
lights are displayed.
CART. JAUNE keys
and remove the "yellow card" penalty.
CART. ROUGE keys
the "red card" penalty, which causes a point to be
assigned to the adversary.
P. MAN. key (Manual priority):
removes the priority.
P. CAS. key (Random priority):
assigns priority. Pressing the key again removes
the priority.
BLOCK key : It is not utilised at the moment.
4 - R E M O T E C O N T R O L
OPERATIONS
The remote control runs on a 9V alkaline battery. It
transmits approximately
To replace the battery, the two screws on the rear
side must be removed.
recommended because their life is about 4 times
l o n g e r t h a n t h e c a r b o n - z i n c c e l l .
functioning of the remote control is shown by a red
light on it, while correct reception is indicated by a
illuminated yellow light (TÉLÉCOM.RÉCEPT.) on
the Full-Arm-05. Note that if the signal received
comes from another remote control, the yellow light
will be weaker.
The remote control operates by using infrared rays,
so it is important to point it directly at the Full-Arm-
05 (similar to a television remote control). Every
remote control has a unique, unalterable and
inaccessible transmission code and every Full-
Arm-05 can be programmed to recognise any
remote control, but only one at a time. Thanks to
these features, two remote controls can never
control the same apparatus. Furthermore, there is
no limit to the number of apparatus that can be
connected in the same fencing arena. The remote
control supplied with the Full-Arm-05 is already
prepared, so acquisition is necessary only when
the remote control is changed.
For the aforementioned acquisition procedure, see
the two preceding chapters.
5- FULL-ARM-05 OPERATIONS
P l e a s e r e a d C h a p t e r 2 - F U L L - A R M - 0 5
KEYBOARD and Chapter 3- REMOTE CONTROL
KEYBOARD, where all the functions of the keys
are described.
Two PANEL-02 (Art.835) panel repeaters or
LIGHTS-REPEATERS (Art.894) can be connected
to the 2 Data-Line sockets, located on the back of
the Full-Arm-05.
An inexpensive connector doubler (Art.880), useful
9
ENGLISH
and [-] red keys :
: It increases the number of
(right and left): They assign
(right and left): They assign
It assigns and
It randomly
150.000 commands.
Alkaline batteries are
C o r r e c t
They