Prior To Operation - DeWalt DWE1622 Manual De Instrucciones

English
3. Insert the cutter 25 with pilot pin
the flat meets the locking pin. When the flat meets the
locking pin the collar will snap down.
4. Check that the cutter is securely held in the arbor.
5. Lift the collar to release the cutter.
Fig. F
24
26
25
Three-Jaw Chuck (Fig. G)
A 3-jaw chuck 27 can be installed using an adaptor
fit the drill press for various bit sizes. Refer to Inserting and
Removing an Accessory for installation instructions.
nOTE: It may be necessary to adjust the motor position
when chuck is installed. Please refer to Adjusting the Motor
Height for instructions.
Refer to the Accessories section for further information on
appropriate accessories.
Fig. G
24
28
27
Setting the Speed (Fig. H)

CAUTION: Do not change speeds while motor
is running.
The machine is equipped with a two-gear selector to vary
the speed/torque ratio.
1. Rotate the gear selector tab
and shift into the desired mode.
2. Lock the selector tab back into the detent.
lOW sPEED AnD high TORQUE: The yellow dot
should be aligned with position 1 for low speed and
high torque (holes from 32 to 50 mm).
high sPEED AnD lOW TORQUE: The yellow dot
should be aligned with position 2, for high speed and
low torque (holes from 12 to 30 mm).
nOTE : It may be necessary to slightly turn the spindle by
hand a little to complete the gear change.
6
26 and turn until
2
1
28 to
2
1
out of the detent slot
4
29
29
Fig. H
2
1
29
4
Adjusting the Motor Height (Fig. I)
The motor height can be adjusted
to accommodate the need for more or less bit clearance
over the workpiece.
1. Loosen the motor slide bolt
key tool 31 .
2. Position the motor to the desired height.
3. Tighten the bolt firmly with the hex tool to secure the
motor in position.
Fig. I
2
1
OPERATION

WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING:
• Apply only a gentle pressure to the tool. Excessive
force does not speed up drilling but decreases tool
performance and may shorten tool life.
• It the accessory jams, stop the motor and gently
raise the accessory out of the workpiece before
resuming work.
• Always use the safety chain.

Prior to operation


WARNING: Inspect the chain before each use, for
wear or damage. Replace if necessary.
29
2
1
4
2
1
4
29
30 with the supplied hex
30
31