How To Operate Your Compressor - DeVilbiss Pulmo-Aide 3655A Guía De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6

HOW TO OPERATE YOUR COMPRESSOR

NOTE– Before initial operation, your nebulizer should be
cleaned by following the cleaning instructions, or
as recommended by your physician or Sunrise
provider.
1. Make sure the power switch is in the "Off" (O)
position (Fig. 1).
2. Unwrap power cord.
3. Place compressor so that the rubber feet are
resting on a level, sturdy surface (Fig. 2) and
upon which the controls can be easily reached
when seated. Never block the air openings of the
product or place it on a soft surface, such as a
patient's lap or a bed or couch where the air
openings may be blocked.
4. Plug power cord into an appropriate wall outlet.
DeVilbiss compressor/nebulizer must be operat-
ed on the specified power source to avoid risk
of electric shock and damage to the compressor.
5. Wash hands.
6. Connect one end of the nebulizer tubing to the
compressor air-outlet connector (Fig. 2).
NOTE–During high-humidity weather conditions, con-
densation (water build up) can occur in the neb-
ulizer tubing.
7. Assemble clean nebulizer parts by placing baffle
down in medication cup. Add prescribed med-
ication into the medication cup (Fig. 3).
Holding cup stationary, screw on nebulizer cap
(Fig 4).
8. Assemble mouthpiece and t-piece (if applicable)
and insert into the top of the nebulizer cap. If
using an aerosol mask, insert the bottom part
of the mask directly into the top of the nebuliz-
er cap.
SE-655
H o w t o O p e r a t e Y o u r C o m p r e s s o r
DANGER
O
Figure 1
Figure 2
Figure 3
Figure 4

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pulmo-aide 3655sePulmo-aide 3655u

Tabla de contenido