Installation: Polaris 50 Mobile - Dräger Polaris 50 Manual De Usuario

ENG
After inserting the wall mounting arm, first install the ring "A",

then the locking ring "B", followed by the end rings "C".
D
Carefully insert the rotary plug "D".

B
A
C
Attach the joint covers "B" and fit screws "C".

Attach the covers "A".

DANGER
Risk of death from electric shock.

Do not turn on the power supply before the luminaire
head has been installed.

To proceed with the installation of the luminaire head,
see Chapter 6.
32
A
B
C
A
5.

INSTALLATION: Polaris 50 Mobile


Remove the M3 Allen screws on the sides and remove
the power supply tray "A".

Loosen the 2 Allen screws on the lower support tube.

Feed the support tube cable through the roller stand.

Attach the support tube to the roller stand using the 2
Allen screws and serrated washers (10 Nm).

The cable holder must be aligned towards the rear.

Connect the stranded wires of the same colour for the
lower support tube and for the power supply.

Reinstall the power supply tray with the M3 Allen screws
and serrated washers.

Push the plugs on the upper and lower support tube
together until they click.

Place the upper support tube on the lower one.
A