GYS Tool it PBT 824 Manual De Usuario página 9

Translation of the original instructions
OPERATION AND USE
Note: Whenever the tester is connected to a battery, it will perform a quick check of the cable to ensure proper connection.
If the connection is good, the tester will go to the home screen. If the connection is bad, the display will show «CHECK
CLAMPS». In this case, check the cable connections. The clamps may need to be reconnected to the battery or the cable
may need to be replaced if its ends are damaged.
1- Ensure that the area is well ventilated before performing a test.
2- Tester for 12 V batteries and systems for 12 & 24 V charging (Only 12 volt for START & STOP batteries)
3- Before running a test on the battery, make sure the ignition is off, the accessories are also off. Close all the doors and
the boot.
4- Recommended operating temperature: From 0°C (32°F) to 50°C (122°F)
5- Make sure the battery terminals are clean. If necessary, clean them using a wire brush.
Any presence of oxidation between the tester terminals and the battery connectors or between the battery
connectors and the battery terminals reduces the effectiveness of the tester.
6- Ensure that there is a 6 batteries type AA in the battery compartment.
7- Connect the negative (black) terminal to the negative terminal of the battery. Connect the positive plug (red) to the
positive terminal of the battery.
MAIN MENU
Once the clamps are connected, the tester automatically displays the main menu. Use the arrows to scroll through
the main menu features.
Features
Battery test
System test
Vehicle test
Print the last result
Selection of the language
Test count
Date / time change
Brightness
PBT 824
Display screen
BATTERY
TEST
XX.XX V
SYSTEM
TEST
XX.XX V
VEHICLE
TEST
XX.XX V
PRINT
THE LAST
RESULT
LANGUAGE
SELECTION
TEST
COUNT
2018/02/05 13:25:00
BRIGHTNESS
Action
Press "ENTER" to do a battery test
Press "ENTER" to test the system
Press "ENTER" to do a vehicle test
Press "ENTER" to print the last result
Press "ENTER" to change the lan-
guage
Press "ENTER" to see how many
times the battery /
system / vehicle test has been perfor-
med"
Press "ENTER" to set the date and
time. Then press to set "Year".
Press "ENTER" to end the year.
Follow the previous step to complete
month / day / hour and minute.
Press "ENTER" to adjust the bri-
ghtness of the screen.
EN
9