Kohler STERLING SP2270A Serie Guia De Instalacion página 5

Wall Jamb
Lip
Location
Groove
2. Install the Adjustment Blocks
Lay both wall jambs down on a flat surface with the lip facing up.
Slide an adjustment block into each end of the channel of each wall jamb.
Position each adjustment block over the hole on each end of the wall jamb between each of the
location grooves.
Using the blade of a flat-blade screwdriver, tap the wall jamb lip down onto the edges of the
adjustment blocks. This will secure the adjustment blocks in place.
Using a Phillips screwdriver, unthread the adjustment block screws 5/8" (1.6 cm) from the
adjustment blocks.
Repeat this procedure for the second wall jamb.
3. Install the Wall Jambs
Apply a bead of sealant to the full length of the caulking groove on the back side of the wall jamb.
Slightly overfill the groove with sealant.
With the filled groove toward the outside of the shower, position the wall jamb against the wall.
Align the holes in the wall jamb with the holes in the wall.
Secure the wall jamb to the wall with three #8-18 x 1-3/4" panhead screws.
Repeat this procedure for the second wall jamb.
Sterling
Screwdriver
Adjustment
Block Hole
Wall Jamb
Apply a bead of sealant
in the groove.
5
Backside of
Wall Jamb
Position with
filled groove
toward the
outside of the
shower.
Secure with
three #8-18 x
1-3/4" panhead
screws.
#8-18 x 1-3/4"
Panhead Screw
1034050-2-E