Troubleshooting - Nogueira PN-MASTER 3000 Manual De Instrucciones

Troubleshooting

Problem
Excessive machine vibration.
The chopped material is
threadlike, i.e., the cut is
insufficient.
The machine is full-fed.
The belt is slipping.
Causes
The machine is not on a
proper base.
The impeller is unbalanced.
Machine has chocked.
Knives cutting edges is not
good.
Counter knife worn.
Material put in excess inside of
the feeding nozzle.
Impeller speed incorrect.
Knives cutting edges is not
good.
Counter knife worn.
Material put is excess inside of
the feeding nozzle.
Belt very is loosen and/ or dirt
of oil or grease.
PN-MASTER 3000
Solution
Put the machine on a leveled
and rigid base.
Check the quantity, assembled
position and knife weight.
Open the cover of the impeller
compartment and remove the
accumulated material.
Sharpen the knives.
Invert the position or replace the
counter knife.
Supply the machine uniformly
and continuously.
Check the motor power and
pulleys diameter.
Sharpen the knives.
Replace the counter knife.
Supply the machine uniformly
and continuously without
exaggeration.
Adjust the belt tension and clean
the belt.
25