Nogueira PN-MASTER 3000 Manual De Instrucciones página 7

- Moving parts, due to inertia, continue moving
even after the machine is turned off. Before
touching any part, disconnect from its actuation
source, look and listen to make sure there is no
movement. Only touch a part when you are
sure it is motionless. Always pay attention!
- It is prohibited for people to stand on any part
of the machine while operating. Whenever it is
necessary to get on the machine for any
adjustment or repair, turn off the motor and wait
until the components/ parts are completely
motionless.
- Keep people and animals away from the pick-
up area of the machine while it is operating.
- Do not place the machine on cement blocks,
hollow bricks, of other supports which can
crush from a prolonged weight load.
- If you notice any abnormality in the operation,
vibrations, different noises etc., turn off the
machine immediately. Check and eliminate the
cause before turning on again.
PEFORMING MAINTENANCE
1- The machine must be turned off and
disconnected from the tractor when performing
any kind of maintenance and lubrication
procedures.
2- Pay attention to the types and quantities of
lubricants recommended for diverse parts and
components.
PN-MASTER 3000
TRANSPORTING ON A TRUCK
Whenever it is necessary to transport the
machine longer distances, or it is necessary to
travel on public roads, it must be transported by
truck or on a semi-trailer truck.
The machine must be completely inside the
truck body or on the semi trailer carrying it.
HANDLING THE MACHINE WITH
A WINCH OR FORKLIFT
Whenever it is necessary to handling the
machine when it is still in the box, use a fork lift
properly and never lift it using straps or cranes.
When it is necessary to lift the machine outside
of the box, use appropriate straps and fasten
them to the adequate places.
7