HoMedics enviraScape WFL-CAN32 Manual De Instrucciones Y Garantía página 4

5. Set the fountain top onto the base so it sits level.
6. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this
time (Fig. 1).
7. Set the fountain on a level, waterproof surface.
8. Plug the cord into 120V household outlet. The fountain is controlled by the switch
located on the power cord. If pump doesn't operate, rotate in-line switch once to turn
"on" and once more to turn "off". Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip
Loop' (Fig. 4). This will prevent water from running down the cord into the electrical
outlet.
9. Arrange the rocks provided around the base of the candles. (If splashing occurs,
rearrange rocks until their is no more splashing).
Figure 4
Drip Loop
6
Maintenance
Caution:
• To keep water clean:
All servicing of
Periodically change water and clean the product according to the
this fountain must
water condition. Keeping the water clean prevents the water from
be performed by becoming sticky and forming micro-organisms. We recommend
distilled water to prevent mineral build-up.
authorized
• To clean off hard water deposits on the base:
HoMedics
service Use a mixture of vinegar and water to clean and remove any mineral
build-up on the base and pump.
personnel only.
• Keeping the water at an optimum level:
Add water periodically to keep water level at an optimum level and
to avoid shortening the life of the pump. NOTE: Never let the pump
run dry.
• Fountain Storage
Unplug the fountain from the electrical outlet, empty the water,
and store in a dry, cool place.
Troubleshooting
Attention:
In order to get
• If the pump fails to operate, check the following:
best results,
Check the circuit breaker, or try a different outlet to make sure the
please operate
pump is getting electrical power. NOTE: Always disconnect from
pump completely
electrical outlet before handling the pump.
submerged
• If the pump gurgles, spews, or "burps":
Check the water level to make sure the pump has
enough water to function.
• Obtaining a desired water level:
Check the water level daily the first week to measure the
rate of evaporation; refill with water as needed.
• If water is splashing outside the fountain:
Adjust the flow control valve to a lower setting on the pump.
7