Krups EA815 Manual De Instrucciones página 32

PROBLEM MALFUNCTION
The coffee dispenses too
slowly.
Water or steam comes out
abnormally from the steam
nozzle.
The coffee fineness knob is
difficult to turn.
The espresso or coffee is not
hot enough.
The coffee is too lightly co-
loured or too weak.
The appliance is not produ-
cing coffee.
Why can I not run descaling/
why does my machine not re-
quest a descaling cycle?
A power failure occurs during
a cycle.
The appliance is working but
no liquid is coming out.
Coffee grains have found their
way into the drip tray.
Only a qualified technician is authorised to carry out repairs on electrical wiring and carry out work
Danger :
on the electrical grid. If you do not follow these instructions, you risk death by electrocution! Do not use an
appliance that is visibly damaged!
30
CORRECTIVE ACTION
Turn the coffee fineness knob to the right to make the grounds courser (this
could also depend on the type of coffee used).
Run one or several rinsing cycles.
Run a machine clean (see "Cleaning program").
Change the Claris Aqua Filter System cartridge (see "Installing the filter").
At the beginning or end of making a drink, the steam nozzle may drip slightly.
Only change the grinder setting when it is running.
Increase the coffee temperature in the Maintenance and settings menu
Warm the cup by rinsing it with hot water before making the drink.
Avoid using oily, caramelised or flavoured coffee. Check that the coffee bean
container has coffee in it and that it is dispensing correctly.
Decrease the drink volume, increase the drink strength.
Turn the coffee fineness knob to the left to make the grounds finer.
Make the drink in two cycles by using the 2 cups function.
A problem has been detected during preparation of the drink.
The appliance has restarted automatically and is ready for a new cycle.
The machine only requests a descaling cycle once it has made a certain num-
ber of drinks using steam.
The appliance is automatically restarted when power is switched back on.
Check that the water container is in the correct position and that the cord is
not jammed between the appliance itself and the water container.
This happens if coffee grains fall outside the percolation tank; this keeps the
machine clean.
.