Citrus Press; Guarantee & Service - Philips HR7772/50 Manual De Instrucciones

EnglisH
12
2 To reassemble, push the beaters back into the balloon beater
housing.

citrus press

Always clean the citrus press immediately after use.
The citrus press can be cleaned in the dishwasher. You can also pull the
cone from the sieve to clean them separately.
1 Pull the cone from the sieve (Fig. 41).
2 To reassemble, push the cone back on the sieve of the citrus press.
storage
1 Push the cord into the cord storage compartment on the back of
the motor unit. (Fig. 42)
Environment
- Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the
environment (Fig. 43).
guarantee & service
If you need service or information or if you have a problem, please visit
the Philips website at www.philips.com or contact the Philips Consumer
Care Centre in your country (you find its phone number in the
worldwide guarantee leaflet). If there is no Consumer Care Centre in
your country, go to your local Philips dealer.
troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your
country.
Problem Solution
When I select a Make sure the food processor or blender jar and
speed or press the its lid are assembled correctly ('click').Make sure
pulse/Easy Clean that the tool holder has been inserted properly if
button, appliance you are using any accessory with the food
does not start to processor bowl. If you use the blender jar, make
operate. sure that the handle of the blender points to one
of the four corners of the motor unit. Keep the
lid fixed to avoid spillage. If you use the food
processor, make sure that the bowl handle is
directly above the closed lock symbol. The bowl
lid is correctly assembled when the projection is
locked into the slot of the bowl handle. If all parts
are assembled correctly, the appliance starts to
operate when you select a speed with the speed
selector or press the pulse/Easy Clean button.
The The thermal safety cut-out has probably cut off
appliance suddenly the power supply to the appliance because the
stops running. appliance has overheated. 1) Unplug the
appliance. 2) Let the appliance cool down for 1
hour. 3) Put the mains plug in the socket. 4)
Switch on the appliance again.
I have selected the Check the colour of the attachment and choose
wrong speed for the corresponding speed with the speed selector.
the attachment I
want to use.
The emulsifying Make sure the emulsifying disc, balloon beater or
disc, balloon kneading accessory is assembled properly onto
beater or kneading the tool holder. Also make sure the food
accessory does not processor bowl and the lid are assembled
turn. properly ('click').
12