Toothbrush Handle - Philips Sonicare HX6322/04 Manual De Instrucciones

14
English
Activating or deactivating the Easy-start feature
1 Place the handle on the charger.
To activate Easy-start:Press and hold the power on/off button for 2
seconds. You hear 2 beeps to indicate that the Easy-start feature has
been activated.To deactivate Easy-start:Press and hold the power
on/off button for 2 seconds. You hear 1 beep to indicate that the
Easy-start feature has been deactivated.
Note: Using the Easy-start feature beyond the initial ramp-up period
is not recommended and reduces Philips Sonicare effectiveness in
removing plaque.
Cleaning
Warning: Do not clean brush heads, handle, charger in the
dishwasher.

Toothbrush handle

1 Remove the brush head and rinse the metal shaft area with warm
water. Make sure you remove any residual toothpaste (Fig. 10).
Caution: Do not push on the rubber seal on the metal shaft with
sharp objects, as this may cause damage.
2 Wipe the entire surface of the handle with a damp cloth.
Brush head
1 Rinse the brush head and bristles after each use (Fig. 11).
Charger
1 Unplug the charger before you clean it.
2 Wipe the surface of the charger with a damp cloth. Make sure you
remove any toothpaste or other residue from the charger surfaces.
Storage
If you are not going to use the Sonicare for an extended period of
time, unplug the charger from the electrical outlet, clean it and store it
in a cool and dry place away from direct sunlight.