Smartpond DP700UV Manual De Instrucciones página 7

Step 1. Before cleaning,
always disconnect the
pump from the power
source and remove the
inlet screen.
Step 2. Remove the
impeller housing to
expose the impeller
assembly.
Step 3. Remove the
impeller assembly by
gently pulling on the
impeller blades. The
impeller is held in place
by a magnet.
Step 4. Use a soft cloth
or brush and warm water
to clean the impeller, the
inside of the impeller
housing and rotor housing.
Step 5. Reassemble all
pump parts, place pump
inside the pumpshield ,
®
and place in water before
reconnecting to the
power source.
In order to insure optimal performance of the UV bulb, periodic
cleanings must be performed. Lower performance is an
indication that cleaning is needed.
Step 1. Unplug pump, untie the
1
drawstring on the pumpshield® and
then remove the pump from pond.
Remove the screw located on the
center of the rear filter screen.
PLEASE CALL CUSTOMER CARE BEFORE RETURNING ITEM TO LOWE'S: 1-888-755-4497 5