Springer DC - R Manual Del Usuario E Instalación página 12

N
OPERATING YOUR AIR CONDITIONING APPLIANCE (FOR REMOTE CONTROL UNITS ONL Y)
LIGA/DES
By pressing the
CONDITIONING ON or OFF on the remote control. When
you turn on the equipment, the LEDs on the electronic panel will
display the information from the previous programming. When you
turn it off, all LEDs turn off as well. When you change any setting
on your remote control, the electronic panel on the inside unit will
acknowledge the change with a "BEEP". Don't worry if you try to
turn on the equipment again in less than 3 minutes and it does not
respond immediately, as this is normal procedure controlled by an
internal safety device on the compressor.
By pressing the FUNCTION keys you can select the desired
FUNÇÃO
OPERATION MODE.
AQUEC.
REFRIG.
AQUEC.
On (HEAT)mode the equipment will raise the selected
temperature between 18 and 29 ºC. When switching the
VENT.
OPERATION MODE to
AUTO
will assume the last selected temperature. If this is not the lowers
12
LIGA/DES
key you turn your ELECTRONIC AIR
AQUEC.
(HEAT) the electronic controller