Installation Instructions - Springer DC - R Manual Del Usuario E Instalación

N

INSTALLATION INSTRUCTIONS

THROUGH-THE-WALL INSTALLATION
The opening in the wall must allow the perfect fit of a framework to fix the appliance,
as well as to give a decorative finishing. Remember that the wooden beams of the framework
must be of at least of 2.5 cm thick.
You must have in mind that the wall you choose to install the unit on must be free of
pillars, girders, pipelines and electrical ducts. According to the following table and the previous
figure, chose the internal sizes of the framework:
Dimensions
18.000 Btu/h
24.000/30.000Btu/h
- Its better to install your appliance on the walls facing east or
south, where solar incidence is weaker.
- avoid using the cooling function of your appliance with indoors
temperatures lower than 20ºC, so ice may not be formed on the
internal heat exchanger
- To avoid freezing of the external heat exchanger, do not use the
heating function with outdoors temperatures lower than 4ºC.
-WHENEVER you want to change from the cooling function
to the warming function, or conversely, turn off the equipment and
wait at least 2 minutes before turning it on again.
- If electrical energy is interrupted, immediately turn your
unit off and turn it on again just after 1 minute of the energy re-
establishment. This procedure will avoid damage to the compressor
due to tension variations.
- Do not use the circuit breaker as switch to turn on-off the
equipment. The circuit breaker is the principal safety device of its
electrical circuit.
A B
65 43,5
67 47
4
C (máx.)
25
28