Clearing Commands; Master Clear; Tv/Vcr/Input; Ir Extender Feature - Philips PH750T Manual Del Propietário

Clearing Commands

To Clear all Learned Commands under a mode
Clearing learned commands is helpful if, for example, you
replace your CD player with another brand or model. If
you had learned a feature from your old CD player's
original remote on to this remote (such as RANDOM
PLAY), that feature would no longer work for your new
CD player. Should you wish to remove or clear one or
more "learned" commands, follow the steps below:
1. Press and hold the CODE SEARCH button until the
red indicator turns on. Release the CODE SEARCH
button.
2. Press and release the button for the mode you want
to clear (TV, VCR, etc.). The red indicator blinks off.
3. Press and release the LEARN button TWICE. The
red indicator blinks off.
4. Press and release the CODE SEARCH button. The
red indicator turns off. All learned Commands under
that mode are now cleared.
Master Clear - To Clear all Learned
Commands under all modes
1. Press and hold the CODE SEARCH button until the
red indicator turns on. Release the CODE SEARCH
button.
2. Press and release the LEARN button TWICE. The
red indicator blinks off.
3. Press and release the CODE SEARCH button. The
red indicator turns off. All Learned commands in the
remote are now cleared.

TV/VCR/INPUT

When in TV mode the TV/VCR/INPUT button performs
the INPUT source switch function.
When in a mode that has been programmed for VCR the
TV/VCR/INPUT button performs the TV/VCR antenna
switch function.
When in a mode that has been programmed for Cable the
TV/VCR/INPUT button performs the A.B switch
function.
When in a mode that has been programmed for SAT the
TV/VCR/INPUT button performs the TV/SAT switch
function.
When in a mode that has been programmed for DVD the
TV/VCR/INPUT button performs the DVD Setup
function.
18

IR Extender Feature

The IR extender feature lets you use your remote
control to control the A/V product that the Audio/
Video Sender is connected to. E.G., if the Audio/
Video Sender is connected to a DVD Player, or
VCR in your living room, and the Audio/Video
Receiver is connected to a TV in your bedroom;
you can control the DVD Player or VCR while
watching the picture from it on the TV in your
bedroom. The remote sends Radio Frequency (RF)
commands to the Audio/Video Sender (the unit
with the thin antenna on it). It receives the RF
commands from your remote and converts them to
Infrared (IR) commands. You plug the IR extender
cable into the jack on the back of the Audio/Video
Sender and attach the IR emitters to the front of
the DVD Player, or VCR, etc. that you want to
control.
1. Plug the IR extender jack on the IR emitter
cord into the IR EXT. socket located on the
back of the Audio/Video Sender.
2. Place the emitter cord in front of the two
devices you want to control (e.g., DVD and
VCR).
3. Make sure that the two IR emitters are
attached close to the IR sensors on the devices
you want to control.
DVD VCR
IR emitter
The IR emitter cord lets you control up to two IR
devices.
19
Audio/Video
Sender.
LEFT RIGHT DC 12V
IR EXT. VIDEO IN AUDIO I N
IR extender jack
IR emitter