CleanForce CF1800HD Manual De Referencia página 14

aSSEMBLY aND OpEraTION INSTrUCTIONS
4 Turn on the pressure washer. Depress trigger to operate unit. The liquid
detergent will automatically mix with water, and be discharged through the
nozzle. Apply detergent to a DRY work surface, from bottom to top.
5 Allow detergent to remain on the surface for a short time before rinsing. Do
not allow detergent to dry on surface.
6 Rinse with clean water under high pressure. On a vertical surface, rinse from
the bottom up, then rinse from the top down to avoid streaking. Hold nozzle
6-8" (15-20 cm) from the cleaning surface, at a 45° angle.
7 When you have finished using the detergent dispensing system, fill de-
tergent tank with clean water to rinse the system clean. Depress the gun
trigger for one minute at low pressure so that all detergents remaining in
system are thoroughly flushed out. Remove detergent tank to empty the
remaining water, and rinse it until it is thoroughly cleaned.
CaUTiOn
Fail to follow detergent clean procedure will cause the dispensing system to
become clogged.
Damage may occur to painted surface if chemical is allowed to dry on surface.
Wash and rinse a small section at a time. Avoid working on hot surfaces or in
direct sunlight.
Never use:
• Bleach, chlorine products and other corrosive chemicals
• Liquids containing solvents (i.e., paint thinners, gasoline, oils)
• Tri-sodium phosphate products
• Ammonia products
• Acid-based products
These chemicals will harm the unit and will damage the surface being cleaned.
13