Safety Features - CleanForce CF1800HD Manual De Referencia

IMpOrTaNT SaFETY INSTrUCTIONS
Warning
Connect directly to outlet. Extension cords are not recommended, the use
of an extension cord will override the GFCI built into the plug of the power
supply cord resulting in the risk of electrical shock.
DOUBLE-INSULATION INSTRUCTION
In a double-insulation product, two systems of insulation are provided instead of
grounding. No grounding is provided on a double-insulated product, nor should
a means for grounding be added to the product.
Servicing a double-insulated product requires extreme care and knowledge of
the system, and should be done only by qualified service personnel. Replace-
ment parts of a double-insulated product must be identical to the parts they
replace. A double-insulated product is marked with the words "DOUBLE-INSU-
LATION" or "DOUBLE-INSULATED". The symbol "
the product.
TOTAL STOP SYSTEM (TSS)
The pressure washer is equipped with a total stop system (TSS) that will sense when the
trigger on the gun is depressed or released. It will open the power circuit to the motor, and
cause the pressure washer motor to stop. The motor will start again when the trigger is
depressed.
Warning
The pressure washer is also equipped with a main power "ON/OFF" switch
located on the unit. It should always be moved to the "OFF" position
when the pressure washer is not being used to prevent possible injury or
damage.
SaVE THESE inSTrUCTiOnS

SaFETY FEaTUrES

4
" may also be marked on
Ground Fault Circuit
Interrupter Protection
This device provides additional
protection from the risk of electrical
shock. Plug the Ground Fault Circuit
Interrupter (GFCI) into a power outlet.
Indicator should turn red. TEST
BEFORE EACH USE. Press the
"TEST" button. Red indicator should
disappear. Press "RESET" button
again for use. Do not use if above test
fails.