Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
aSSEMBLY aND OpEraTION INSTrUCTIONS
Surface Preparation
Before starting any cleaning task, it is important to inspect the area for objects that could
create a hazard. Remove any objects from the work area that could be tripped over, such
as toys or outdoor furniture. Ensure that all doors and windows are closed tightly.
Water Supply (Cold Water Only)
Only draw water through the unit. For use with cold water supply only. Garden hose must
be at least a 1/2" (13 mm) in diameter. Flow rate of water supply must not fall below 2
GPM (gallons per minute) [9.1 LPM (liters per minute)]. Flow rate can be determined by
running the water for one minute into an empty 5-gallon (19 L) container. The water supply
temperature must not exceed 104°F (40°C).
CaUTiOn
•
Never use the pressure washer to draw in water contaminated with solvents (e.g.
paint thinners, gasoline, oil, etc.).
•
Dirt in the water inlet will damage the unit. To avoid this risk, we recommend checking
the water filter (located inside the water inlet. To clean it out, see Maintenance
section).
•
Always prevent debris from being drawn into the unit by using a clean water source
and an additional accessory water filter if required.
•
To prolong the life of the unit, rest the unit for 5 minutes after every 30 minutes of use.
MACHINE ASSEMBLY
Raise handle to upright position and
fix the position by cam – lock.
Attach hand cranks onto the hose reel
and cord reel on both sides.
7
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
