Wiring Instructions - Allen + Roth LP8075LBN Manual Del Usuario

WIRING INSTRUCTIONS

WARNING
To avoid possible electrical shock, be sure electricity is turned off at the main fuse box before wiring
this fan.
NOTE: If you are not sure if the outlet box is grounded, contact a licensed electrician for advice, as it
must be grounded for safe operation.
NOTE: Remote (H) has 16 different code combinations. To prevent possible interference from or to
other remote units, simply change the combination code in the transmitter and receiver.
1. To set the transmitter code, remove battery
cover on remote (H) by pressing firmly below
arrow and sliding cover off. Slide code
switches to your choice of up or down position.
Factory setting is all up. Do not use this
position. With a small screwdriver or ball point
pen (not included), slide firmly up or down.
Replace battery cover on remote (H).
2. To set the receiver unit (I) code, slide code
switches to the same positions as set on
remote (H).
1
H
2
I
11
12V
Battery
Lowes.com/allenandroth