Replacement Parts; How To Use The Remote Control; The Remote Control Battery - LiftMaster PASSPORT PPV3M Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

PROGRAMMING (CONTINUED)

OPTION 3 – RE-PROGRAMMING FOR SECURITY+2.0

1. Locate the Program button on the remote control.

2. To enter the programming mode on the remote control, press the

program button until the LED on the front of the remote control turns

on.

3. Press and release the remote control button you wish to use:

• 1 time for SECURITY+2.0

4. Exit programming mode by pressing any remote control button except

the button that was just programmed.

5. Press and release the yellow LEARN button on your product or the

PROGRAM button on the LCD. NOTE: The button color on commercial

products may vary.

6. Press and hold the remote control button you programmed in Step 3

until your product's programming LED turns off or the lights flash on

your product.

7. To test, press the programmed button on the remote control and the

product will activate.

HOW TO USE THE REMOTE CONTROL

Press and hold the button down until the door or gate starts to move.

For key chain remote controls with a proximity sensor, hold the remote

control 1-2" away from the reader face and wait for a confirmation beep

or LED from the reader. Operation of the proximity sensor varies

depending on the access control system. For additional information refer

to the owner's manual for the access control system.

THE REMOTE CONTROL BATTERY

To replace battery, open the case as shown. Insert battery positive side

up (+). Replace the battery with only 3V CR2032 coin cell battery.

Dispose of old battery properly.

VISOR REMOTE

Pry open the case first in the

middle (1), then at each side

(2 and 3) with the visor clip.

Battery

PRODUCTS

product (Yellow LEARN button).

KEY CHAIN REMOTE

Pry open the case with a

screwdriver blade.

To prevent possible SERIOUS INJURY or DEATH:

• NEVER allow small children near batteries.

• If battery is swallowed, immediately notify doctor.

To reduce risk of fire, explosion or chemical burn:

• Replace ONLY with 3V CR2032 coin batteries.

• DO NOT recharge, disassemble, heat above 212° F (100° C) or

incinerate.

NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of

this receiver and/or transmitter are prohibited, except for changing the code setting or replacing

the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS.

Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference, and (2) this device

must accept any interference received, including interference that may cause undesired operation.