THE REMOTE CONTROL BATTERY
The lithium battery should produce power for up to 3 years. To replace battery:
2
1
Use the visor clip or
screwdriver to pry open
the cover.
HOW TO USE THE REMOTE CONTROL
Press and hold the button down until the door or gate starts to move. The remote control will
operate from up to 3 car lengths away on typical installations.
Installations and conditions vary, contact an installing dealer for more information.
REPLACEMENT PARTS
3V CR2032 Lithium battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .10A20
Visor Clip (not available for mini-remote controls). . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29B137
3
Remove the old battery.
Insert replacement batteries
Dispose of old batteries
positive side up. Replace
.
the batteries with only
properly
3V CR2032 coin cell
batteries.
3V CR2032
4
Replace cover.
3-BUTTON REMOTE CONTROLS
®
Additional buttons on any Security+
remote control or mini-remote control can be programmed
®
to operate other Security+
garage door openers, light controls, gate operators or access control
systems.
ONE YEAR LIMITED WARRANTY
LiftMaster warrants to the first retail purchaser of this product that is free from defect in materials
and/or workmanship for a period of 1 year from the date of purchase.
To prevent possible SERIOUS INJURY or DEATH:
• NEVER allow small children near batteries.
• If battery is swallowed, immediately notify doctor.
To reduce risk of fire, explosion or chemical burn:
• Replace ONLY with 3V CR2032 coin batteries.
• DO NOT recharge, disassemble, heat above 212°F
(100°C) or incinerate.
NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment
or modifications of this receiver and/or transmitter are prohibited, except for
changing the code setting or replacing the battery. THERE ARE
NO OTHER USER SERVICEABLE PARTS.
Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation
is subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.