AirKing 2EJR6J Manual De Instrucciones De Operación Y Partes página 3

Installation
The large number of window styles and types makes it impossible
to describe one universal installation procedure. The methods
outlined below are recommended as being well-suited for most
common styles of double-hung windows. Whichever method you
choose should allow the window to be closed easily for security
and protection of home furnishings against the weather. Refer to
illustrations while following Methods A or B below.
METHOD A: (Outside of Trim)
Tools Required: Hardware Provided:
Screwdrivers Four - #8 x 3/4" slotted head screws
1. Loosen screws "B"
and extend side pan-
els to clear the outer
edge of trim on each
side of window.
2. Rest fan on window sill with flange on side panels over trim. Push in
side panels tight against outer edge of trim.
3. With side panel in posi-
tion, mark screw loca-
tions at top of slot "C"
and drive in the 4 wood
screws "A" (provided)
until tight.
4. Tighten 4 screws "B" in
fan housing to complete
installation.
METHOD B: (Inside of Trim)
Tools Required: Hardware Provided:
Screwdrivers Four - #8 x 3/4" slotted head screws
1. Mark screw locations on
inside edges of window trim
using enclosed template as
shown in illustration.
2. Drive 4 screws "A" into trim.
DO NOT TIGHTEN FLUSH.
Leave
1/8" (3.2 mm) space between
screw heads and window trim.
Rev. K 11/17
MODEL 2EJR6J/9155J
B
Figure 1
Slot
C
B
Figure 2
B
B
1/8" (3.2mm)
A
Figure 3
3. Loosen 4 screws "B"
and entend panels
on each side of
housing until the fan
fits snugly between
right and left window
trim.
4. Mount fan in window
by engaging slots "C"
with screws "A" on
inside edge of trim.
Lower fan on screws
"A" until it rests on
window sill or sash
moulding.
5. Tighten screw "B" on
housing to secure
fan in position.
Operation
This Air King® window fan is powered by a durable electrically-reversible
3 speed split capacitor motor. (Hi, Medium, and Low speed settings are
available for both intake and exhaust mode.) The motor control switch
is conveniently located on the motor cover. Adjust knob to direction and
speed desired.
MAINTENANCE
WARNING:
BEFORE MOVING OR SERVICING THE FAN.
WARNING:
CLEANING:
soap solution, such as liquid dish washing detergent.
Dry ALL PARTS COMPLETELY before reassembling.
After any maintenance or servicing, COMPLETELY
REASSEMBLE unit as described in this instruction
manual before reconnecting to the power supply.
CAUTION:
ner, harsh cleaners, etc. as they will damage
the Fan. NEVER use ALCOHOL OR SOLVENTS.
LUBRICATION:
factory for life and will not require any further lubrication.
STORAGE:
Store the Fan, with these instructions, in a cool, dry place.
DISPOSITION:
Corrugated packaging materials are recyclable. For
environmentally responsible disposal of this product, contact your
local waste service provider or visit www.1800recycling.com®.
3
B
Slot
C
B
Slot
C
A
B
A
B
ALWAYS UNPLUG THE CORD
DO NOT IMMERSE FAN IN WATER!
Use a soft cloth moistened with a mild
Do not use gasoline, benzine, thin-
Precision bearings are sealed at the
Figure 4
Figure 5
Figure 6
2082048A