Wds (Wireless Distribution System) - Steren COM-840 Manual De Instrucciones

4.5.1.3.

WDS (Wireless Distribution System)

If you have selected WDS or AP+WDS mode in Wireless Basic-Radio. Mode,
please do the following configurations either by AP scan or manual input.
WDS Name: SSID of connecting wireless router/AP should be entered.
WDS MAC Address: The MAC address of connecting access point
should be entered.
Current WDS Information: Illustrates basic information of all wireless
bridges in connection status. You may delete unnecessary bridges.
• Example: If you are using this router to spread the wireless coverage of
another router, or to spread the coverage to another router, you can use
WDS. For this example, WDS will be established between two routers that
will be referred to as R1 (primary) and R2 (secondary). You may need to
note the LAN IP and MAC address of each router, which may be printed on
a label on the bottom of the router, or may be found in the routers' interfaces
in the "LAN Info" tab of "System Information".
Please follow the steps below, but keep in mind that if one router in this setup
is not Netis you should first confirm it is capable of WDS, and its interface
menu may be considerably different:
R1:
•
35