Static User - Steren COM-840 Manual De Instrucciones

4.4.3. Static User

If you are using a static IP, you will need to input your "WAN IP address,"
"Subnet Mask"," Default Gateway" and "Primary DNS" (domain name
server)" according to information provided by your ISP.
WAN IP address: Please get this from your ISP.
Subnet Mask: Please get this from your ISP.
Default Gateway: Please get this from your ISP.
Default MAC Address: The MAC address of the WAN port is a fixed,
unique address assigned by manufacturer.
Clone MAC address: The WAN port of the router has a unique MAC
address assigned by the manufacturer. It is the "Default MAC". "Clone MAC
address" to apply your connected computer's MAC address to the router, as
is often required by ISP.
MTU: The MTU (Maximum Transmission Unit) setting specifies the
largest packet size permitted for network transmission. Most DSL users
should use the value 1492.You can set
the MTU manually, and you should leave
this value in the 1200 to 1500 range. If
the value you set is not in accord with the
value of your service provider, it may
causes problems.
Primary DNS: The DNS server translates
domain or website names into IP addresses.
The most common DNS server address
you use or one provided by your ISP
should be entered.
Secondary DNS: The IP address of a
backup DNS server should be input here,
or you can leave this field blank.
29