Maintenance And Cleaning - Steelcase 1439125001 Manual De Instrucciones

®
WORKSTATION DESIGN TIPS
• Ensure that power cords for all accessory items – computer, lights, monitors, etc. – are of sufficient length to reach outlets throughout the range of worksurface height adjustment.
Do not subject the cords to any strain while height adjustment is taking place.
• Always check for proper operating clearance before placing any item on, above or below the worksurface.

MAINTENANCE AND CLEANING

Regularly clean dust and dirt from lifting columns. To ensure all surfaces are thoroughly cleaned, make sure the lifting columns are fully extended to their maximum height.
Also, be sure to inspect cables and lifting columns for damage. Check all connections for both correct function and secure mounting.
Note: Please do not move the desk without help. Refer to the guidelines at the end of the assembly instructions, or contact your facilities group for assistance.
TROUBLESHOOTING
If you are having trouble with your desk, try the simple steps outlined below. If problems persist, please refer to the Solo Sit-to-Stand Desk troubleshooting guides.
DESK WILL NOT FULLY ADJUST
1. Check that the power cable is fully plugged into the outlet.
2. Check that the power cable is fully plugged into the control box under the desk.
3. Check that the desk is not overloaded. The weight load should be evenly distributed.
4. Synchronize the motor and control as outlined on the next page.
CHECK FOR POWER
1. Verify that the power cord is fully plugged into the control box found under your desk.
2. Check that your desk is fully plugged in at the outlet on the panel, wall or power strip
located under the desk.
Page 4 of 25
P/N 1439125001
Doc # 156986 Rev A