advance to the correct hour. The PM indicator will light when the hour
is advanced into the PM time.
While holding down the ALARM button, press the MIN button to
advance to the correct minute.
Release the ALARM button when the correct alarm time is shown on
the display
USING THE ALARM
Slide the ALARM ON/OFF switch to the ON position. On the front of the
clock the alarm indicator will be lit.
Slide the ALARM ON/OFF switch to the OFF position to deactivate the
alarm. The alarm indicator will no longer be visible.
TO USE THE SNOOZE FEATURE
Press the SNOOZE/LIGHT button after the wake-up alarm sounds will
cause the alarm to stop and the alarm will sound again in five minutes.
This will repeat each time the SNOOZE/LIGHT button is pressed. The
snooze indicator "Zz" will be flash to confirm snooze function is
activated.
TO USE THE BACKLIGHT FEATURE
Press the SNOOZE/LIGHT button to illuminate display backlight five
seconds for your night viewing.
CARE OF YOUR CLOCK
A soft cloth or a paper towel may be used to clean your clock. Do not
use any corrosive cleanser or chemical solutions on the clock. Keep the
clock clean and try to avoid any problems.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
User's Manual
7
E N